Pier Fishing in California

Resources :: Reel Rebuilds

Shimano - Hotrodding a Trinidad/Torium 16/20/30

By Alan Tani

I got the Carbontex drags a while back and finally had a chance to go through the Torium. this was a brand new reel, straight out of the box. Here’s a shot of the reel with three Carbontex drags and a Penn HT-100. going right to left, you see a coarse weave Carbontex, next a thinner fine weave Carbontex, another coarse weave Carbontex, and a standard Penn HT-100 #6-320.

Shimano Trinidad/Torium Reel

First, let’s remove the handle (key #’s 128, 603, 262, 604 and 264)

Shimano Trinidad/Torium Reel

Now the star (key # 605), the washers underneath (key #’s 266, 267, 268, 269, 270), the click pin and spring (key #’s 295 and 296), and the bearing (key # 486) if you can get to it.

Shimano Trinidad/Torium Reel

Now back out the side plate screws (key #’s 606, 305 and 306), noting first the difference in the shapes of the screw heads. remove the right side plate (key # 607) and set it aside.

Shimano Trinidad/Torium Reel

Now pull the gear/drag cluster out (key #’s 287, 288, 289, 288, 290, 291, 292 and 418) and line everything up. In the photo, I cleaned off the black grease so you could tell the difference between the carbon and metal washers. The carbon tex washers are lined up as well.

Shimano Trinidad/Torium Reel

Here’s a shot of the base with the guts in place. Note that the anti-reverse ratchet (key #294) is also still in place. You’ll save yourself some time this way.

Shimano Trinidad/Torium Reel

Now we’re going to rebuild the drag cluster. I like to slap a generous coat of grease on the washers. Use more or less if you’d like. This is just what I do.

Shimano Trinidad/Torium Reel

Dig the roller clutch inner tube (key # 494) out of the roller clutch bearing (key #493). Place the roller clutch inner tube over the drive shaft (key # 609) and seat it into the key washer (key # 287). Wiggle the side plate on. Don’t forget the line clip (key # 280). You always wondered what that was there for, huh!

Reverse all the above steps and reassemble the reel. The only tricky part left is the installation of the click pin and spring. I install the drag spring washers (key #’s 267 and 268) and the star drag washer (key # 266) first, then install the click spring and pin (key #’s 295 and 296). Push the pin down with a small flat screwdriver and wedge the star drag washer over the top of the click pin. When you spin on the star (key #605), the pin will stay in place.

So I spooled up this Torium 16 and got 18#’s of smooth drag. A Trinidad 20 that I worked on yesterday had 10#’s of drag with Dartaniums, and 15#’s of drag with Carbontex. Needless to say, i’m very happy with Carbontex!